Diecast Aluminum Enclosures 1590-RIBBED Series

Features

• Rugged, diecast aluminum alloy (tough - yet easy to machine), electronic instrument enclosure.
• Lap joint construction provides protection against access of dust and splashing water. Also provides for improved EMI/RFI shielding.
• Unpainted version is vibra finished for a smooth surface with no sharp edges.
• Satin black painted version is painted with tough polyester powder paint for a lasting finish, even after machining. Black screws are included to enhance appearance.
• Includes screws threaded into factory-tapped holes. Screw type and quantity vary.  See details below or in drawings.
• Standard versions are designed to meet IP54.
• Water-tight versions are designed to meet IP65 and include a gasket which is supplied loose inside the enclosure (not pre-installed).
• Low side wall draft angle (2 degrees or less) for easy P.C. board mounting.

Hardware

Replacement Hardware

 

Tamper-proof Hardware Upgrade (Torx w/ Pin)

 

Gaskets

NOTE: Gaskets are included with watertight 1590 enclosures.  They can also be purchased as a kit if you'd like to upgrade an IP54 enclosure to IP65.  Not available for all sizes.

• Each kit includes two pre-formed silicone gaskets.
• Gaskets include adhesive backing for easy installation.
• Allows enclosure to be machined and/or painted first and gasketed later.
• Gasket is applied to the lid.
• Designed to meet IP65 with properly installed gasket and lid screws torqued to 25-30 cN.m (36-43 ozf.in).
• Refer to part number table below for correct gasket.

Notes

• Lid height is 0.16" (4 mm).