Eddystone Die-Cast Enclosures (EDDYSTONE Series)

Rugged diecast aluminium alloy electronic instrument enclosure.
Diecast material is tough yet easy to machine.
Aluminium alloy to BS1490, LM2M supplied in natural finish.
Eddystone designed. The Eddystone brand was purchased by Hammond in 1998.
Lap joint construction provides protection against access of dust and splashing water.
Lids are retained by M3.5 x 12 countersunk screws (POZIDRIV No. 2 head).
Countersunk lid holes.
Designed to meet IP54.
Low side wall draft angle (2° or less) for easy PC board mounting.

Click Part No, below, for details (e.g., Product drawings, assembly instructions, ship weight)

Units shown: mm. Switch units to: inch

Part Number	Length	Width	Total Depth	Lid Height
11451PSLA	53	38	27	4
27969PSLA	92	38	31	4
27134PSLA	112	61	31	4
29830PSLA	121	96	34	4
26908PSLA	121	96	57	4
11130PSLA	125	125	75	4
10758PSLA	145	95	45	4
26827PSLA	189	120	56	4
26357PSLA	189	120	82	4

Data subject to change without notice.

Eddystone Die-Cast Enclosures EDDYSTONE Series